[mythtv-users] backend on multiple networks

[Raymond Wagner]

On 5/19/2012 10:26, Preston Crow wrote:
> When I configure the backend in mythtv-setup, I need to configure an IP
> address, and it uses that to determine which interface to bind to when
> opening the ports.  From a security standpoint, this is good, as you
> don't want to accidentally put these ports out where anyone on the
> Internet can connect to your backend.  However, I don't see how to tell
> it to bind to multiple devices.

At the moment there is not.  The backend will only listen to the IP 
address selected there.  Further, while previous versions would listen 
everywhere, that IP address was used for frontends to know where to 
connect to, so it would not have worked previously.  Hopefully for 0.26, 
I plan to have that replaced with a multi-selector, to allow users to 
define multiple IP addresses specifically for this purpose.