[mythtv-users] backend on multiple networks
Mitch Capper
mitch.capper at gmail.com
Sat May 19 15:22:15 UTC 2012
You already mention you use ssh tunnels, just continue to do that (or
switch to the somewhat easier stunnel) it should work just fine that
way.
~Mitch
On Sat, May 19, 2012 at 7:54 AM, Raymond Wagner <raymond at wagnerrp.com> wrote:
> On 5/19/2012 10:26, Preston Crow wrote:
>>
>> When I configure the backend in mythtv-setup, I need to configure an IP
>> address, and it uses that to determine which interface to bind to when
>> opening the ports. From a security standpoint, this is good, as you
>> don't want to accidentally put these ports out where anyone on the
>> Internet can connect to your backend. However, I don't see how to tell
>> it to bind to multiple devices.
>
>
> At the moment there is not. The backend will only listen to the IP address
> selected there. Further, while previous versions would listen everywhere,
> that IP address was used for frontends to know where to connect to, so it
> would not have worked previously. Hopefully for 0.26, I plan to have that
> replaced with a multi-selector, to allow users to define multiple IP
> addresses specifically for this purpose.
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://www.mythtv.org/mailman/listinfo/mythtv-users
More information about the mythtv-users
mailing list