[mythtv-users] mythfilldatabase ran, but did not insert any new data

[William Powers]

I presume that you ran mythfilldatabase during the migration and got ~ 
12.75 days worth of guide data?  Then, a few hours later, the normal, 
daily DataDirect transaction ran and produced the message you cited?  If 
so, I don't believe there is anything unusual about that, since there 
was probably no new information available.  However, if it doesn't work 
the next day, then that would be a problem.

Gary Lerhaupt wrote:

>I followed the guidelines to transition from xmltv to datadirect.  I set
>up my account, redid the setup and mythfilldatabase performs (or seems
>to perform) as I would expect it.  However, I don't get any guide
>information, and from status, it tells me that 
>
>mythfilldatabase ran, but did not insert any new data into the Guide. 
>This can indicate a potential grabber failure.
>
>Interestingly, when I go into myth setup and look at the channel editor,
>it does not show any channels there.  As well, though this is probably
>unrelated, I recently started getting segfaults from klipper whenever
>going into init 5.  Further, I can no longer even change the channel and
>am stuck permanently on ABC (channel 3).  Each time I try to change the
>channel, it just shows the info as (-1440 minutes).  If I bring up the
>guide, it is completely empty (doesn't even say Unknown) and if I try to
>move the cursor, the frontend completely dies.
>
>I have updated and recompiled as of cvs today.  I have done a lot of
>searching through the list and have not seen anyone else report similar
>behavior.  Any thoughts?
>
>Thanks,
>Gary
>
>
>  
>
>------------------------------------------------------------------------
>
>_______________________________________________
>mythtv-users mailing list
>mythtv-users at mythtv.org
>http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>  
>