[mythtv-users] no channels found HDHR3-4DC

[Dennis Alders]

Karl,

On Wednesday, September 10, 2014, Karl Dietz <dekarl at spaetfruehstuecken.org>
wrote:

> On 10.09.2014 11:53, Dennis Alders wrote:
>
>      After looking at
>>     http://www.silicondust.com/__support/instructions/dvb-c/
>>     <http://www.silicondust.com/support/instructions/dvb-c/>
>>     my thoughts relating DVB-C mostly apply only to USB/PCI adapters.
>>
>>     Looks like you have to configure your device to a8qam64-6875 (see the
>>     end of the instructions) and then scan the frequency in MythTV. That
>> is
>>     based on the two links above.
>>
>>
>> Yes, I know but I cannot configure the symbolrate.
>>
>
> I'm not a native speaker, so I may be misunderstanding something but I
> understood the information from Kenni together with the information
> from these instructions like this:
>
> You set the modulation (QAM64) and symbolrate (6875000 symbols/s) by
> running the following on the command line
> hdhomerun_config FFFFFFFF set /sys/dvbc_modulation "a8qam64-6875"
>
> Then you tell mythtv-setup to scan on a frequency (the modulation and
> symbol rate being left open / on auto) and together with the network_id
> setting all multiplexes are set up from that.
>
>
I tried this already - tried it again since you suggested it -  but does
not work. I guess there is no relation between the hdhomerun software and
mythtv.

Thanks,
Dennis
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.mythtv.org/pipermail/mythtv-users/attachments/20140911/30c267da/attachment.html>