[mythtv-users] How to have 2 pvr150's with 2 ir blasters active?

Rick rbonafied at gmail.com
Sat Sep 13 03:53:47 UTC 2008


Hi,

I'm running Mandriva 2008.1  2.6.22.18-desktop-1mdv with my own compiled
version of myth (svn.021-fixes).  Everything is working great, that is
until I decided to try out the IR blasters.

I've been following the various guides on getting lirc compiled to use
the blaster firmware. I have a single blaster working just fine.
However, when I plug in the second ir blaster to the second pvr-150 I
don't find that it is recognized.  I hope I'm missing something obvious
and just need some fresh advice.

To recap just a bit:
   On boot the modules 'lirc_dev' and 'lirc_pvr150' are loaded fine.

   I only see a single /dev/lirc0 device file.  I think I should see two
if both remote dongles (with blaster) were active.  Is that true?

Any suggestions?

Rick
------
Output from log:
Sep 12 23:43:45 myhost kernel: lirc_dev: IR Remote Control driver
registered, major 61
Sep 12 23:43:45 myhost kernel: lirc_pvr150: chip found with RX and TX
Sep 12 23:43:45 myhost kernel: lirc_dev: lirc_register_plugin:
sample_rate: 0
Sep 12 23:43:45 myhost kernel: lirc_pvr150: firmware of size 302355 loaded
Sep 12 23:43:45 myhost kernel: lirc_pvr150: 743 codesets loaded
Sep 12 23:43:45 myhost kernel: lirc_pvr150: Hauppauge PVR-150 IR
blaster: firmware version 1.3.0
Sep 12 23:43:45 myhost kernel: lirc_pvr150: ivtv i2c driver #1: no
devices found


More information about the mythtv-users mailing list