[mythtv-users] HDHomeRun and 0.21-fixes r17645
Alen Edwards
allen.edwards at oldpaloalto.com
Fri Jul 11 16:23:27 UTC 2008
Khanh Tran wrote:
> I'm trying to get an HDHomeRun setup with 0.21-fixes r17645, but when
> I add the video source to the tuner and try to run the channel scan,
> it won't detect the card as an available card to scan channels.
>
> If I have my PVR-250s setup, it will only show those cards, otherwise,
> mythtv-setup says it cannot connect to the card. If I leave the HDHR
> setup, but without a video source attached, mythbackend.log will show
> it detects the HDHR, but won't start due to the lack of channels.
> I've tried clearing all cards and starting with just the HDHR, but no
> luck. It works beautifully from the command line outside of myth
> too...
>
> Anyone?
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
The problem I had was that the HDHR was not recognized on bootup, which
confused me no end until I figured it out. The solution was to change
my IP address to static although I have been told that DHCP (not
roaming) would also work.
The other thing I found was that following the instructions on the
Mythbuntu HDHomerun wiki slowly and one step at a time, even though they
seemed illogical to me, worked much better.
And finally, I deleted all channels, all channels on this machine, did
that three times and did it again after deleting the source, then
deleted the source again. Then I installed the HDHR the last time and
it worked. I spent about 3 hours trying to install the HDHR. This is
what worked.
Of course, looking at "Information" "Machine Status"?? and "Tuner
Status" is helpful in figuring out what is going on.
Allen
More information about the mythtv-users
mailing list