[mythtv-users] Black borders when output on TV- Any advice? M10000
TBARKER at qinetiq.com
Fri Sep 3 04:22:26 EDT 2004
Where would i do that? does that just move mythtv about on the screen then?
Could it be to do with modelines? and if so what should i use for a 50hz pal
Have you tried turning OverScan on and then adjusting the mythtv screens in
myth so that you see the whole >>picture again? I had the same problem on
one of my tvs and this seemed to fix it (lowering pixel by pixel screen size
in myth and recentering it) rgds anders
The Information contained in this E-Mail and any subsequent correspondence
is private and is intended solely for the intended recipient(s).
For those other than the recipient any disclosure, copying, distribution,
or any action taken or omitted to be taken in reliance on such information
is prohibited and may be unlawful.
Emails and other electronic communication with QinetiQ may be monitored.
Calls to QinetiQ may be recorded for quality control,
regulatory and monitoring purposes.
More information about the mythtv-users