[mythtv-users] Tuning fails on Nova S2 HD with "Error parsing parameters" 29.1
Paul Gardiner
lists at glidos.net
Tue May 28 15:48:28 UTC 2019
On 28/05/2019 11:28, Mike Bibbings wrote:
> Ignore my previous comment about the Escape key, it was due to me using
> ssh to run mythtv-setup on remote machine, the Left arrow comment still
> applies.
>
> I am assuming that mythbackend has been stopped before using
> mythtv-setup using systemctl commands in a terminal session and is
> running on a debian based operating system with systemd (includes
> current Ubuntu etc).
>
> If you get the "WARNING: The backend is currently running" screen with
> Stop Backend and Continue highlighted (it does not actually stop
> mythbackend), select Exit and use a terminal session
>
> sudo systemctl stop mythtv-backend
>
> then
>
> mythtv-setup
>
>
> I have rechecked on current mythtv 29 (built from source).
>
> The only times I get the "Error parsing parameters" message with Full
> Scan (Tuned) using defaults for my tbs 6981 tuners) :
>
> 1. No Frequency is set.
>
> 2. Frequency includes non numeric characters, only numbers 0-9 should be
> used, no decimal point, commas etc.
>
> For Astra 28E2 satellite I use and only have to set Frequency and Symbol
> Rate
>
> Frequency: 10714000
>
> Polarity: H (default)
>
> Symbol Rate: 22000000 (default was 27500000)
>
> Mod Sys: DVB-S (default)
>
> FEC: Auto (default)
>
> Modulation: QPSK (default)
>
> Inversion: Auto (default)
>
> Roll-off: 0.35 (default)
I'm not even getting to the screen where I could set those values. It's
hitting "Scan" on the screen before this one that gives the error.
More information about the mythtv-users
mailing list