[mythtv-users] Ceton ETH6
Jay R. Ashworth
jra at baylink.com
Tue Dec 15 16:13:43 UTC 2015
----- Original Message -----
> From: "Gary Buhrmaster" <gary.buhrmaster at gmail.com>
> On Thu, Dec 10, 2015 at 9:57 PM, Gary Buhrmaster
> <gary.buhrmaster at gmail.com> wrote:
> ....
>> NOTE NOTE NOTE NOTE: You should check
>> your eth6 label on the bottom, but I could have
>> sworn that that device used a 12V supply.
>
> And btw, according to a post over on the greenbutton
> forum, apparently the Ceton power bricks can "fail" and
> result in increased levels of "flakyness" which can
> go away with a higher quality replacement supply.
> As this is a common failure mode for consumer device
> power supplies I am not surprised (the SD HDHR
> and the various Hauppauge devices are notorious
> about power supply issues causing flaky with the
> usual cause being increased ripple voltages due to
> caps failing; age matters).
Sloth often works well for me; I hadn't seen these til now, but I also
haven't had time to play with the box yet. I will double check the power
issues before firing it up; thanks for the warning.
Cheers,
-- jra
--
Jay R. Ashworth Baylink jra at baylink.com
Designer The Things I Think RFC 2100
Ashworth & Associates http://www.bcp38.info 2000 Land Rover DII
St Petersburg FL USA BCP38: Ask For It By Name! +1 727 647 1274
More information about the mythtv-users
mailing list