[mythtv-users] mythfilldatabase finds no schedule info--Solved

[Tom Ashley]

Thanks for all the responses.  After being away for a couple of hours, I 
ran mythfilldatabase again and it works.  It appears the problem was on 
the SD side.  At any rate, it works!

Thanks again.


On 10/19/2014 03:17 PM, R. G. Newbury wrote:
> On 19/10/14 02:13 PM, Tom Ashley wrote:
>> Updating source #1 (antenna) with grabber schedulesdirect1
>> 2014-10-19 13:38:56.505292 I  No channels are configured to use grabber.
>> 2014-10-19 13:38:56.505332 I
>
> Not sure which end of the pipe that error refers to.
> So first check on the SD website that you have a lineup defined, and 
> channels enabled (you might get that message if every channel in the 
> lineup is disabled. Would not hurt to Re-add you lineup, on the 
> lineups page.
>
> Then, running mythtv-setup check that you have a capture card defined. 
> [OK)a video source defined (eg OTA and have run a scan if OTA, 
> otherwise 'fetched') [OK]  and finally linked the card and input 
> connection in Videosources.
> Since you say you successfully scanned for channels, I suspect that 
> something is wrong with the last step.
>
> BUT NOTE: check also on the second page of the capture card setup, to 
> ensure that 'Open card when needed' (or something like that) is 
> checked, and 'Enable EIT is disabled'... EIT monopolizes the card and 
> messes up the installation, sometimes. And you don't need it anyway.
>
> HTH. There cannot be much else left to do!
>
> Geoff
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://www.mythtv.org/mailman/listinfo/mythtv-users
> http://wiki.mythtv.org/Mailing_List_etiquette
> MythTV Forums: https://forum.mythtv.org