[mythtv-users] mythfilldatabase finds no schedule info--Solved
Tom Ashley
tomashleyjr at gmail.com
Mon Oct 20 01:49:08 UTC 2014
Thanks for all the responses. After being away for a couple of hours, I
ran mythfilldatabase again and it works. It appears the problem was on
the SD side. At any rate, it works!
Thanks again.
On 10/19/2014 03:17 PM, R. G. Newbury wrote:
> On 19/10/14 02:13 PM, Tom Ashley wrote:
>> Updating source #1 (antenna) with grabber schedulesdirect1
>> 2014-10-19 13:38:56.505292 I No channels are configured to use grabber.
>> 2014-10-19 13:38:56.505332 I
>
> Not sure which end of the pipe that error refers to.
> So first check on the SD website that you have a lineup defined, and
> channels enabled (you might get that message if every channel in the
> lineup is disabled. Would not hurt to Re-add you lineup, on the
> lineups page.
>
> Then, running mythtv-setup check that you have a capture card defined.
> [OK)a video source defined (eg OTA and have run a scan if OTA,
> otherwise 'fetched') [OK] and finally linked the card and input
> connection in Videosources.
> Since you say you successfully scanned for channels, I suspect that
> something is wrong with the last step.
>
> BUT NOTE: check also on the second page of the capture card setup, to
> ensure that 'Open card when needed' (or something like that) is
> checked, and 'Enable EIT is disabled'... EIT monopolizes the card and
> messes up the installation, sometimes. And you don't need it anyway.
>
> HTH. There cannot be much else left to do!
>
> Geoff
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://www.mythtv.org/mailman/listinfo/mythtv-users
> http://wiki.mythtv.org/Mailing_List_etiquette
> MythTV Forums: https://forum.mythtv.org
More information about the mythtv-users
mailing list