[mythtv-users] Starting recordings early and finishing late not working
Michael T. Dean
mtdean at thirdcontact.com
Tue Mar 2 18:41:49 UTC 2010
On 03/02/2010 08:19 AM, Ian Oliver wrote:
> I have set recordings to start 300 secs early and finish 600 secs late
> in both places I could find in the front end menus. The main one was at
> Setup->TV->General, and I changed "Time to record before start of show"
> and "Time to record past end of show."
>
That is only used to allow capture cards/hard drives/STB's to "spin up"
before the show starts. It's not scheduled, and is /never/ used between
back-to-back shows recorded by the same capture card.
> I also changed the setting for new recording rules, but I don't think I
> have any of those and don't know where to set them.
>
That only affects any recording rules you create *after* you change the
setting. All it does is pre-fill the start early and end late fields
for you.
> Programmes don't seem to be starting to record early - we're losing the
> first few minutes/seconds. However, we do seem to have the 10 minute
> buffer on the end.
>
> Where should I be setting this?
In each and every recording rule, change start early and end late to the
desired over-record values, but note that doing so makes it "mandatory"
for the recording rule, so if you don't have sufficient capture cards,
you will get conflicts.
Mike
More information about the mythtv-users
mailing list