[mythtv-users] PVR-150(non-mce) Sound Quality
Brian Wood
beww at beww.org
Tue May 30 14:58:39 UTC 2006
On May 30, 2006, at 8:05 AM, cweisiger at i-55.com wrote:
> I have a pvr-150(non-mce) and a pvr-350 in my system.
>
> The sound quality is wonderful on my pvr-350, of which I
> have the coax cable hooked directly to it.
>
> The pvr-150(non-mce) has my cable box hooked to it using
> the composite(yellow, red, white). The picture quality is
> great but the sound is scratchy, with a slight hissing sound.
> Could this be that the sound is going from the red, white jacks
> to the single sound input of the pvr-150.
What is the sound like coming directly from the cable box? If that's
bad the card will not fix it. The "single sound input" of the PVR-150
is just the two channels in one connector, the connector type will
not directly cause the sound to be poor.
Many cable boxes have a sound level control, usually set with the
remote. Be sure that you have set that to a reasonable setting,
probably near the middle of the range or a bit higher.
I have a satellite receiver going directly into a PVR-150 and it
sounds as good as the audio output of the receiver is to start with.
As was mentioned, be sure you are using decent cables.
>
> Would the sound quality be better with a pvr-150 MCE version?
No. Although the MCE uses two RCA connectors instead of the one 1/8"
jack of the non-MCE version, audio quality should be the same as far
as a human ear can determine.
More information about the mythtv-users
mailing list