[mythtv-users] FC5 and Fusion DVB-T Dual Digital

Wed Jul 26 21:45:58 UTC 2006

Gee, I really dont know if it is the same...

And no - for me that was about it. It started working at that point.

At what point do you get that message? When I run "dmesg | grep
dvb-usb" I get the following:
---DMESG START---
dvb-usb: found a 'DViCO FusionHDTV DVB-T Dual USB' in cold state, will
try to load a firmware
dvb-usb: downloading firmware from file 'dvb-usb-bluebird-01.fw'
dvb-usb: generic DVB-USB module successfully deinitialized and disconnected.
dvb-usb: found a 'DViCO FusionHDTV DVB-T Dual USB' in warm state.
dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
dvb-usb: schedule remote query interval to 150 msecs.
dvb-usb: DViCO FusionHDTV DVB-T Dual USB successfully initialized and connected.
---DMESG END---

How much of that do you get?

On 7/26/06, Anthony Goddard <anthony at bondimaging.com> wrote:
> Hi, Thanks for the info. I have run what you suggested, and it downlaoded the firmware file for me. Is running the firmware install like this any different from running wget http://linuxtv.org/firmware/dvb-usb-bluebird.fw?
>
> The firmware is now in /lib/firmware, and it recognises it on bootup, but I still have this in my dmesg:
>
> dvb-usb: no frontend was attached by 'DViCO FusionHDTV DVB-T Dual USB'
>
> In /dev/dvb/ I have "adaptor0"
>
> Is there anything else I need to install to get the frontend attached?
>
> Cheers!
>
> Anthony
>
>
> -----Original Message-----
> From: mythtv-users-bounces at mythtv.org on behalf of Shanon Mulley
> Sent: Wed 7/26/2006 9:28 PM
> To: Discussion about mythtv
> Subject: Re: [mythtv-users] FC5 and Fusion DVB-T Dual Digital
>
> Well this is embarressing. It seems my notes at home arnt as thorough
> as I thought they were.
>
> I'll try to do it from memory:
> install kernel-doc (yum install kernel-doc)
> Now under /usr/share/doc/kernel-doc-2.6.17/Documentation/dvb/, you
> should have the file get_dvb_firmware. Make this file executable
> (chmod 777 get_dvb_firmware), run it with the bluebird option
> (./get_dvb_firmware bluebird), and follow the instructions given.
> The firmware file should end up in /lib/firmware/
>
> Thats about it really - the bit sticking point for me was working out
> I needed to install kernel-doc to get the script to get the firmware.
>
> I hope this helps.
>
> On 7/26/06, Shanon Mulley <shanonmulleyster at gmail.com> wrote:
> > Kevin,
> >
> > from my very limited experience with this, the firmware for the USB
> > portion of the card is retreived by a script. This script comes along
> > with kernel-doc (or something). If you dont have kernel-doc installed,
> > then there is no script. My installation of FC5 did not install
> > kernel-doc by default.
> >
> > On 7/26/06, Kevin Hayes <wondecla at tpg.com.au> wrote:
> > > On Wed, 26 Jul 2006 14:45:19 +1000
> > > "Anthony Goddard" <anthony at bondimaging.com> wrote:
> > >
> > > > Hi All,
> > > > I have put together the following setup:
> > > >
> > > > 3Ghz Pentium-D D/core
> > > > Fedora Core 5 32bit - Kernel 2.6.17-1.2157_FC5smp
> > > > Nvidia FX6200 with TurboCache (using s-video out)
> > > > Fusion DVB-T Dual Digital tuner (the Australia / Europe one)
> > > >
> > > >
> > > > I can install mythtv-suite through yum, but I run into all sorts of
> > > > problems with building the dvb drivers after that.
> > > > Basically I install mercurial, in the /root directory I run "hg clone
> > > > http://linuxtv.org/hg/v4l-dvb"
> > > > then inside the v4l-dvb folder I run make.
> > > >
> > > > I keep running into all sorts of errors when trying to run this.
> > > >
> > > > Before I get into too many specifics, I was just wondering if there's
> > > > anyone out there with a similar setup who knows if I need to do anything
> > > > different to get it working.
> > > > I've been working off Jarrad Wilson's guide as well as
> > > > http://mythtv.org/wiki/index.php/DVICO-Ultraview_Install_in_Australia
> > > >
> > > > I have also installed the firmware (.fw file) before, but had errors
> > > > with frontend not initializing still
> > > > I have had Myth running fine on the same box running FC4.
> > > >
> > > >
> > > > Because I played around a lot and thought I might have done more damage
> > > > than good, I've formatted and reinstalled FC5 at this stage, so all i
> > > > have done is a yum upgrade & a yum install Kernel-Devel, and nothing
> > > > further, and this is my dmesg. (I have only pasted the part that look
> > > > relevant).
> > > >
> > > > Hope someone can help!
> > > >
> > > > Cheers,
> > > > anthony
> > > >
> > > >
> > > > hub 3-0:1.0: 2 ports detected
> > > > usb 1-5: new high speed USB device using ehci_hcd and address 2
> > > > ACPI: PCI Interrupt 0000:00:1d.2[C] -> GSI 18 (level, low) -> IRQ 177
> > > > PCI: Setting latency timer of device 0000:00:1d.2 to 64
> > > > uhci_hcd 0000:00:1d.2: UHCI Host Controller
> > > > uhci_hcd 0000:00:1d.2: new USB bus registered, assigned bus number 4
> > > > uhci_hcd 0000:00:1d.2: irq 177, io base 0x0000b400
> > > > usb usb4: configuration #1 chosen from 1 choice
> > > > hub 4-0:1.0: USB hub found
> > > > hub 4-0:1.0: 2 ports detected
> > > > cx2388x v4l2 driver version 0.0.5 loaded
> > > > usb 1-5: configuration #1 chosen from 1 choice
> > > > cx2388x dvb driver version 0.0.5 loaded
> > > > ACPI: PCI Interrupt 0000:00:1d.3[D] -> GSI 16 (level, low) -> IRQ 169
> > > > PCI: Setting latency timer of device 0000:00:1d.3 to 64
> > > > uhci_hcd 0000:00:1d.3: UHCI Host Controller
> > > > uhci_hcd 0000:00:1d.3: new USB bus registered, assigned bus number 5
> > > > uhci_hcd 0000:00:1d.3: irq 169, io base 0x0000b800
> > > > usb usb5: configuration #1 chosen from 1 choice
> > > > hub 5-0:1.0: USB hub found
> > > > hub 5-0:1.0: 2 ports detected
> > > > ACPI: PCI Interrupt 0000:04:00.0[A] -> GSI 20 (level, low) -> IRQ 233
> > > > CORE cx88[0]: subsystem: 18ac:db50, board: DViCO FusionHDTV DVB-T Dual
> > > > Digital [card=44,autodetected]
> > > > TV tuner 4 at 0x1fe, Radio tuner -1 at 0x1fe
> > > > dvb-usb: found a 'DViCO FusionHDTV DVB-T Dual USB' in cold state, will
> > > > try to load a firmware
> > > > dvb-usb: did not find the firmware file. (dvb-usb-bluebird-01.fw) Please
> > > > see linux/Documentation/dvb/ for more details on firmware-problems. (-2)
> > > > dvb_usb_cxusb: probe of 1-5:1.0 failed with error -22
> > > > cx88[0]/0: found at 0000:04:00.0, rev: 5, irq: 233, latency: 32, mmio:
> > > > 0xe5000000
> > > > cx88[0]/0: registered device video0 [v4l2]
> > > > cx88[0]/0: registered device vbi0
> > > > ACPI: PCI Interrupt 0000:04:00.2[A] -> GSI 20 (level, low) -> IRQ 233
> > > > cx88[0]/2: found at 0000:04:00.2, rev: 5, irq: 233, latency: 32, mmio:
> > > > 0xe6000000
> > > > cx88[0]/2: cx2388x based dvb card
> > > > cx88[0]: frontend initialization failed
> > > > cx88[0]/2: cx8802_stop_dma
> > > > cx88-dvb: probe of 0000:04:00.2 failed with error -1
> > > > cx2388x blackbird driver version 0.0.5 loaded
> > > > usb 5-1: new full speed USB device using uhci_hcd and address 2
> > > > usb 5-1: configuration #1 chosen from 1 choice
> > > > usbcore: registered new driver dvb_usb_cxusb
> > > > ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 16 (level, low) -> IRQ 169
> > > > PCI: Setting latency timer of device 0000:00:1b.0 to 64
> > > > hw_random hardware driver 1.0.0 loaded
> > > > parport: PnPBIOS parport detected.
> > > > parport0: PC-style at 0x378, irq 7 [PCSPP,TRISTATE]
> > > >
> > > >
> > > Hi, have been playing around with this card for a few weeks now,
> > > and have it working successfully on a Win2K partition also
> > > on a MythDora partition out of the box
> > >
> > > I can see from your log that it is not finding the firmware file,
> > > I'm currently trying to get it detected on a Slackware  10.2 partition
> > > where i got the same message, i googled for it and put it in
> > > /lib/firmware after that it was detected correctly,
> > > and all the error messages above disappeared, and it seems to
> > > be correctly detected, except it is not detected in the myth-setup.
> > >
> > > That is where i'm now, it works very well for my on the MythDora
> > > partition,
> > >
> > > hth
> > >
> > > --
> > > Kevin Hayes
> > >
> > > _______________________________________________
> > > mythtv-users mailing list
> > > mythtv-users at mythtv.org
> > > http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
> > >
> >
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
>
>