[mythtv-users] PVR-250 Setting bitrate

[Joe Byrne]

Jim,

What's the post-install command that you use to set bit rates?

JB

----- Original Message ----- 
From: "Jim Chandler" <jim at chandler.net>
To: "Discussion about mythtv" <mythtv-users at mythtv.org>
Cc: <gbs at alumni.brown.edu>
Sent: Wednesday, October 15, 2003 11:03 AM
Subject: Re: [mythtv-users] PVR-250 Setting bitrate


> I use the post-install command in my /etc/modules.conf file so that it
> gets run after ivtv gets put into the kernel.
>
> Jim
>
> On Wed, 15 Oct 2003 11:30:34 -0400
> Graham Siener <gbs at alumni.brown.edu> wrote:
>
> > I'm running Myth .11 with a PVR 250.  I don't want to record at full
> > bitrate, rather at 5Mbps/8Mbps peak.  I've set this with
> >
> > # /usr/lib/ivtv/test_ioctl -c bitrate=5000000,bitrate_peak=8000000
> >
> > But upon restart, this setting is reset.  If I set this when the backend
> > is off, it works fine.  But I would like the setting to stick without
> > having to change it back all the time.  I thought I could do this
> > through setup->tv setup->recording settings, but it doesn't seem to
> > work.
> >
> > With 5/8 an hour is about 2.4GB/hr, and 8/18 gives me 3.6.
> >
> > Sorry if this was too wordy, I just wanted to make sure I was clear.
> > I've searched but haven't really found anything...
> >
> > Any suggestions?  Thanks for the help!
> >
> > Graham
> >
> >
>