[mythtv] RedHat 8.0 couldn't open db fix

Brent Norris brent at biglinux.tccw.wku.edu
Wed Jan 29 06:27:14 EST 2003


I use the RPMS from Freshrpms.net all the time.  I don't have any
problem with them.  Are you sure you had the lame-devel rpm installed?

On Wed, 2003-01-29 at 00:51, kevind at depfyffer.com wrote:
> After the third night of pulling my hair out I found the problem. I was
> getting errors during Make on mythtv but didn't pay attention, when I ran
> setup I would get "couldn't open db" ok it a mysql problem right?
> Nope go figure its because of the error's I was getting while doing make
> on mythtv. If you have RedHat 8.0 do not use the lame RPM use ./configure
> make make install and the problem is gone. I don't have a clue whats
> getting lost in the RPM but it doesn't work. It's probably my fault from
> getting the rpm from that fresh place. Don't get me wrong I'm not nocking
> it but being lazy can cause a lot of pain.
> 
> 
> _______________________________________________
> mythtv-dev mailing list
> mythtv-dev at snowman.net
> http://www.snowman.net/mailman/listinfo/mythtv-dev
-- 
Brent Norris <brent at linux.wku.edu>



More information about the mythtv-dev mailing list