[mythtv-users] Homerun Prime Watchdog resets

[Mike Perkins]

On 19/10/14 15:13, Peter Bennett (cats22) wrote:
> My homerun prime was hanging every few minutes, and would then reset
> itself. The homerun system log is cleared out and starts fresh with a
> message "System: reset reason = watchdog".
> I had it replaced under warranty, and now the replacement is doing the
> same thing, this time with less frequency, about three times a day.
> Mostly this happens when no recording is taking place, but when it
> happens during a recording that recording is lost or cut short.
> It happened at least three times yesterday, which I discovered by
> looking at the log from time to time.
> Both this unit and the unit I returned have firmware version 20140604.
> It started happening on that unit some time after I installed that firmware.
> Has anybody experienced this or have any suggestions?
> I believe that these units do not allow downgrade of firmware.
>
I would consider the power supply as a likely suspect. Change that and see what 
happens.

-- 

Mike Perkins