[mythtv-users] UDEV rules
Daryl McDonald
darylangela at gmail.com
Sat Jan 25 20:10:06 UTC 2014
On Sat, Jan 25, 2014 at 3:03 PM, Andrew C. (AFPup) Stadt
<acstadt at stadt.ca> wrote:
> On 25/01/14 02:08 PM, Daryl McDonald wrote:
>>
>> And further, on a whim, I went into the BE deleted all capture cards, then
>> rebooted, and then went in again and was still not presented with symlink
>> names, only /dev/adapter0/frontend0, /dev/adapter1/frontend0, /dev/video0,
>> /dev/video24, /dev/video36, and only by backspacing and typing can I get
>> /dev/video1, or /dev/video2, they won't present with left/right arrows, but
>> they are recognized as "saa7134" and "Kworld pc150u" so although the
>> symlinks look good, maybe they didn't fully take? I don't fully understand
>> the output from the grep, but my gut feeling is that since I am able to
>> configure the cards, without udev involved, permissions must be correct,
>> right? thanks
>
> IIRC, mythtv-setup only populates the default device nodes in the drop-down,
> eg: /dev/video? for v4l/ivtv/etc devices. You need to select the
> appropriate type of device in the top drop down, then just type in the
> correct device node eg:
>
> /dev/videopvr150
>
> Don't forget the after you define the capture cards, you still need to
> define a source, then connect the appropriate card/input to the appropriate
> source.
>
>
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://www.mythtv.org/mailman/listinfo/mythtv-users
OK So are you suggesting that I ignore the "failed to open" message
and proceed to input connections?
In steppes theme I don't drop down fields I left/right arrow for
different values, and I up/down arrow to change fields. Daryl
More information about the mythtv-users
mailing list