[mythtv-users] EIT fails in some channels

[Per Kofod]

On 01/13/2014 05:02 AM, A. F. Cano wrote:
> On Sun, Jan 12, 2014 at 07:57:51PM -0000, Roger Siddons wrote:
>> ...
>> mythtv-setup/Capture Cards/<tuner>/Recording Options/"Use DVB card
>> for active EIT scan" is the checkbox you're looking for.
> '
> Thanks.  It was actually checked.
>
>> You can verify Active scanning by turning EIT logging on;
>>
>> mythbackend --setverbose eit
>>
>> and you should see messages such as:
>>
>> mythbackend[3835]: I TVRecEvent eitscanner.cpp:269 (StartActiveScan)
>> EITScanner (10): StartActiveScan called with 5 multiplexes
> Just to make sure it works, I did that.  I got: (time stamps removed)
>
>
>  I  MythCoreContext: Connecting to backend server: 127.0.0.1:6543 (try 1 of 1)
>  E  Connection to master server timed out.
>                       Either the server is down or the master server settings
>                       in mythtv-settings does not contain the proper IP address
>
>  E  Unable to connect to backend, verbose mask unchanged 
>
> [1]+  Exit 137                mythbackend --setverbose eit
You need to have mythbackend running, then issue the command
'mythbackend --setverbose eit'

--setverbose                Change debug mask of the existing master
backend.

>
>
> This is puzzling, as this mythtv-settings do contain 127.0.0.1 and the
> listen to link-local checkbox is checked.  The server is down, of
> course, as I'm trying to start it with the command that caused the
> error.  "mythbackend &" (without the --setverbose eit option) works
> just fine.
>
> Mmm... Suggestions, anyone?
>
> Augustine
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://www.mythtv.org/mailman/listinfo/mythtv-users