[mythtv-users] Encoder disappears
barbex
barbex at gmail.com
Wed Sep 29 09:14:54 UTC 2010
> 2010-09-23 11:00:32.304 Channel(/dev/video1)::Open(): Can't open video
> device, error "Permission denied"
> That must be the moment where mythtv realizes
> that the Encoder has "walked away"! Have to check if anything happens
> right before that timestamp.
So, it happened again and I looked at dmesg, messages and syslog - and
there is nothing! The card is registered, gets assigned video1 and
loads the firmware, no errors, no warnings.
Anywhere else I should look?
Is it possible that the tuner is just too slow to answer right after
boot? Can I make Mythtv wait a bit?
More information about the mythtv-users
mailing list