[mythtv-users] How do I have it only use the channels I scanned?
Kevin Kuphal
kuphal at dls.net
Wed Jan 17 14:25:41 UTC 2007
Xamindar wrote:
> Tom Lichti wrote:
>
>> Udo van den Heuvel wrote:
>>
>>
>>> Xamindar wrote:
>>>
>>>
>>>> I have to use mythweb to do this? Oh well, it's a good reason to get
>>>> mythweb set up. Thanks for the info. Is there one box to check to tell
>>>> mythtv to only show the channels that it scanned and found? Selecting
>>>> each channel is going to take some time and I have to keep looking at
>>>> mythsetup to see which channels it found.
>>>>
>>>>
>>> You can also go into the database afterwards, perhaps using phpmyadmin,
>>> and make the channels (in)visible. I guess you need to check the
>>> channels table.
>>>
>>>
>> Or you could use mythtv-setup, as a supported method. MythWeb would be
>> the easiest though, since you can do them en masse, as opposed to one by
>> one.
>>
>> Tom
>>
>> _______________________________________________
>> mythtv-users mailing list
>> mythtv-users at mythtv.org
>> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>>
>>
>>
> Thanks for the replies guys. I'll try your suggestions. I do have one
> last question though. Then what is the point of the channel scanner?
>
It is used, by me, for my HDTV DVB card. My normal PVR devices don't
need it.
Kevin
More information about the mythtv-users
mailing list