[mythtv-users] How do I have it only use the channels I scanned?

Xamindar junkxamindar at gmail.com
Wed Jan 17 08:12:22 UTC 2007

Tom Lichti wrote:
> Udo van den Heuvel wrote:
>> Xamindar wrote:
>>> I have to use mythweb to do this?  Oh well, it's a good reason to get 
>>> mythweb set up.  Thanks for the info.  Is there one box to check to tell 
>>> mythtv to only show the channels that it scanned and found?  Selecting 
>>> each channel is going to take some time and I have to keep looking at 
>>> mythsetup to see which channels it found.
>> You can also go into the database afterwards, perhaps using phpmyadmin,
>> and make the channels (in)visible. I guess you need to check the
>> channels table.
> Or you could use mythtv-setup, as a supported method. MythWeb would be 
> the easiest though, since you can do them en masse, as opposed to one by 
> one.
> Tom
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
Thanks for the replies guys.  I'll try your suggestions.  I do have one
last question though.  Then what is the point of the channel scanner?

More information about the mythtv-users mailing list