[mythtv-users] Encoders 1 and 2 are now 3 and 4

[James Buckley]

Perhaps in the MySQL database. Find where they are stored, and change
something like 'CardID' to 1 and 2. Warning: You will probably have to go
and find any other references to card's 3 and 4 and change them back to 1
and 2. I don't have my Myth box running at the mo, so I'm just guessing...

-----Original Message-----
From: mythtv-users-bounces at mythtv.org
[mailto:mythtv-users-bounces at mythtv.org] On Behalf Of Chris Gentle
Sent: 02 June 2006 21:53
To: mythtv-users at mythtv.org
Subject: [mythtv-users] Encoders 1 and 2 are now 3 and 4

I just finished upgrading my Myth boxes to the 2.6.16 kernel and
ivtv-0.6.2.  I went in and deleted out my capture cards and and then
added them back so that the input sources would be numbered
appropriately, as required by the new ivtv driver.  Everything seems
to work.

However, both System Status and MythWeb's status page now report my
two capture boards as Encoders 3 and 4 and instead of Encoders 1 and 2:

        Encoder 3 is local on mythtv and is not recording.
        Encoder 4 is remote on myth2 and is not recording.

Why did this happen?  Is there any way to set them back to 1 and 2,
since I don't really have four encoders?

Thanks!

-- 
Chris
_______________________________________________
mythtv-users mailing list
mythtv-users at mythtv.org
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users



___________________________________________________________
$0 Web Hosting with up to 200MB web space, 1000 MB Transfer
10 Personalized POP and Web E-mail Accounts, and much more.
Signup at www.doteasy.com