[mythtv-users] Which device is which
Brian Wood
beww at beww.org
Thu Feb 16 23:40:46 UTC 2006
On Feb 16, 2006, at 4:32 PM, Michael Haan wrote:
>
> Yeah, no I mean that the difficulty in telling which modules were
> loaded in response to which hardware or, conversely, which drivers
> each card is using. In any case, I pulled the Fusion5 out leaving
> just the pvr 350 and the HD3000 (again, a config which was working
> before) and grabbed lsmod | sort - here is some of it:
>
> btcx_risc 38857 3 cx8800,cx8802,cx88xx
> button 41185 0
> cx22702 40389 1 cx88_dvb
> cx8800 71373 0
> cx8802 47173 1 cx88_dvb
> cx88_dvb 46429 0
> cx88xx 103265 3 cx8800,cx88_dvb,cx8802
> dm_mod 99337 0
> dv1394 57273 0
> dvb_core 129277 1 video_buf_dvb
> dvb_pll 45509 4 cx88_dvb,or51132,nxt200x,cx22702
>
> I'm posting this because I thought someone said that cx8800 would
> block cx88_dvb, or is it that I can only use one set of functions -
> dvb, or ntsc - at a time (in which case it's ok that both are loaded)?
You may be referring to something I posted, I had read that you could
not load the ntsc and the dvb drivers at the same time. I read this
in the Gentoo HowTo setup MythTV, but I think that information pre-
dated the integration of the hd-3000 drivers into the kernel, and may
no longer be valid.
But I have also seen several references to removing the analog driver
and (re) installing the dvb one.
My system loads both, and I have not seen any problems that I can say
with certainty are related to that, but I would like a definitive
answer, is it OK to load both driver modules ??
I am having some problems with QAM, and if the analog cx88 module is
contributing to them I'd like to know it, otherwise I don't want to
waste time disabling something harmless.
More information about the mythtv-users
mailing list