[mythtv-users] My pvr-250 thinks it's a radio??
Andy
mythtv at gzo.dk
Fri Apr 14 16:38:54 UTC 2006
On Friday 14 April 2006 18:20, Michael T. Dean wrote:
> Notice that the frequency is in the radio range... What if you just
> "change the channel" to a TV channel?
I've seen it. But I can't make anything useful out of it.
This is the output on the "good" first card.
# ivtvctl -d /dev/video0 -R
ioctl VIDIOC_G_FREQUENCY ok
Frequency = 8820
The same card reports
tuner 1-0061: Tuner mode: analog TV
tuner 1-0061: Frequency: 551.25 MHz
tuner 1-0061: Standard: 0x000000ff
When i do
#ivtvctl -d /dev/video0 --log-status
The other card says it is tuned in on the same frequency:
# ivtvctl -d /dev/video1 -R
ioctl VIDIOC_G_FREQUENCY ok
Frequency = 8820
But when i requests a log-status it says this:
#ivtvctl -d /dev/video1 --log-status
tuner 2-0061: Tuner mode: radio
tuner 2-0061: Frequency: 0.55 MHz
tuner 2-0061: Standard: 0x000000ff
tuner 2-0061: Signal strength: 32768
tuner 2-0061: Stereo: yes
I have tried for days to see, if there is some parameter that is set different
on the cards, but i can't seem to find any.
>Also, try the full reset (complete power down for a couple of minutes)
>I mentioned.
I have tried it with no success..
Is it possible to initialize the cards to certain values on boot? (Freq, ect)
Regards
More information about the mythtv-users
mailing list