[mythtv-users] PVR-500 Only one turner works --- Hardware of
Software problem?
Nick Rosier
nick.rosier at gmail.com
Sun Oct 9 17:10:24 UTC 2005
On 09/10/05, Chris Gackstatter <Chris at coldspringdirect.com> wrote:
>
>
>
> I am trying to determine if I have a faulty board or I just have a setting
> that does not work.
>
>
>
>
>
> I am following wilsonet for FC4 instruction. This works great for me as I
> have the identical hardware/software (FC4 and two captures cards PVR250 and
> a PVR500)
>
>
>
> I recently installed the PVR500 following wilsonet and also found on the
> mythtv user mail list the instruction on updating the firmware for the
> PVR500. When I did this I had both tuners on the card working well using
> the cat /dev/video1 > /tmp/test_capture.mpg suggested by willson.
> Unfortunately in my haste to get the card working I screwed up something in
> my mythsetup that caused my hard drive to be filled and I was only able to
> access the system in fail safe mode. I corrected this problem by deleting
> the MySQL database.
>
>
>
>
>
> Just to make sure everything was working correctly I reinstalled the
> firmware for the PVR500 and ran the cat /dev/video1 > /tmp/test_capture.mpg
> test again This time only one of the tuners (video2) worked, video1 just
> gives a gray screen.
>
>
>
> I have checked and re-checked. All my setting re follows the recommendation
> of wilsonet. Normally I would assume that I have a setting wrong, but being
> I have seen these settings work before by backend crash I am beginning to
> suspect a hardware problem.
>
>
>
> Does any one have any suggestions?
>
Check http://ivtvdriver.org/index.php/Troubleshooting and
http://ivtvdriver.org/index.php/Asking_for_help
N.
More information about the mythtv-users
mailing list