[mythtv-users] 0.18.1 on x86_64 and lirc not working
Oliver Groht
oliver.groht at catworkx.de
Sun May 22 18:51:13 UTC 2005
Johan Reinalda schrieb:
> All,
> I have just built a new box, based on FC3-x86_64, installed as plain
> x86_64 without the 32-bit comp. libraries. (on Athlon64 2800+, ECS
> 755-A2 mobo, 512mb, 200gb, pvr-150mce, nvidia fx5200-svid)
>
> Installed lirc 0.7.1 as usual, then installed 0.18.1-x86_64 from the
> at repo (manually downloading rpms, as yum had some dependency
> problems with myth-plugins).
>
> myth runs fine, with one exception: I cannot get lirc support to work.
>
> Using a home brew serial port receiver, the lirc setup shows working
> when testing with 'mode2' (i see pulses), and with 'irw' (I see the
> correct buttom definitions, both as root or as mythtv user). However,
> Myth does not recognize/use lirc...
>
> I have the same setup on a development box, running an older&slower
> original athlon 32bit cpu, and also 0.18.1 (upgraded from the original
> 0.17 install) There things work. I pulled in the following two lirc
> config files from this dev system which work there:
> /etc/lircd.conf
> ~mythtv/.myth/lirrc
>
> One difference I notice is the lack of following type entries in
> /var/log/message (this does show up for irw, not when starting
> mythfrontend) :
>
> May 22 10:41:06 mythtv lircd-0.7.1[3584]: accepted new client on
> /dev/lircd
>
> What am I missing, or is it just that the x86_64 build does not
> support lirc?
>
> TIA,
>
> Johan
>
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
Did you ran irxevent (as the same user as mythfrontend) before you start
up your mythfrontend? It's important.!
Did you try to generate an symbolic link from ~mythtv/.lircrc to
~mythtv/.myth/lirrc ?
Greez
Oliver
More information about the mythtv-users
mailing list