[mythtv-users] Haupauge PVR 150

[Paul Furtado]

I'm new to linux i decided to to start using it as a mythtv box. I
followed the howto on wilsonet.com to install it on fedora. I
installed it fine and setup xmltv and then i purchased the PVR 150
model 1024 from newegg.com. I downloaded and installed IvTv using yum
and atrpms for fedora core 3 at-bleeding. Then i followed the other
instructions in the howto guide to modify the modprobe.conf and start
ivtv. I started the mythtvsetup and I chose the standard V4L capture
card and video 0. Then i finished the rest of the setup and i exited.
I went into the mythtv frontend and i hit watch tv and i was greeted
by a black screen. I tried pressing Esc and it would not exit. I was
forced to restart. Upon restart i ran setup again and it did not
detect Video0 so i exited then started ivtv and then ran setup again
and it detected video0 but it apparently found 2tv tuners 2svideo
ports and 3 composite ports and i only have 1 tuner, 1svideo, 1
composite. Heres my ivtv log
Jun 29 14:33:19 localhost kernel: ivtv: ==================== START
INIT IVTV ====================
Jun 29 14:33:19 localhost kernel: ivtv: version 0.3.5 (l) loading
Jun 29 14:33:19 localhost kernel: ivtv: Linux version: 2.6.11-1.27_FC3
686 REGPARM 4KSTACKS gcc-3.4
Jun 29 14:33:19 localhost kernel: ivtv: In case of problems please
include the debug info
Jun 29 14:33:19 localhost kernel: ivtv: between the START INIT IVTV
and END INIT IVTV lines when
Jun 29 14:33:19 localhost kernel: ivtv: mailing the ivtv-devel mailinglist.
Jun 29 14:33:19 localhost kernel: ivtv: Autodetected WinTV PVR 150 card
Jun 29 14:33:19 localhost kernel: ivtv: Found an iTVC16 based chip
Jun 29 14:33:19 localhost kernel: ACPI: PCI interrupt 0000:00:0e.0[A]
-> GSI 10 (level, low) -> IRQ 10
Jun 29 14:33:19 localhost kernel: ivtv: Unreasonably low latency
timer, setting to 64 (was 32)
Jun 29 14:33:19 localhost kernel: ivtv: XXX PCI device: 0x0730 vendor: 0x1039
Jun 29 14:33:19 localhost kernel: tveeprom: Hauppauge: model = 26552,
rev = B268, serial# = 7970919
Jun 29 14:33:20 localhost kernel: tveeprom: tuner = LG TAPE H001F MK3
(idx = 68, type = 47)
Jun 29 14:33:20 localhost kernel: tveeprom: tuner fmt = NTSC(M)
(eeprom = 0x08, v4l2 = 0x00001000)
Jun 29 14:33:20 localhost kernel: tveeprom: audio_processor = MSP3410D
(type = 5)
Jun 29 14:33:20 localhost kernel: ivtv: i2c attach [client=tveeprom[50],ok]
Jun 29 14:33:20 localhost kernel: ivtv: Tuner Type 47, Tuner formats
0x00001000, Radio: yes, Model 0x00892598, Revision 0x00000001
Jun 29 14:33:21 localhost kernel: ivtv: Radio detected
Jun 29 14:33:21 localhost kernel: tuner: Ignoring new-style parameters
in presence of obsolete ones
Jun 29 14:33:21 localhost kernel: tuner: chip found at addr 0xc2
i2c-bus ivtv i2c driver #0
Jun 29 14:33:21 localhost kernel: ivtv: i2c attach [client=(tuner unset),ok]
Jun 29 14:33:22 localhost kernel: cx25840: Unable to open FW file
'/lib/modules/HcwMakoA.ROM'.
Jun 29 14:33:22 localhost kernel: cx25840: Failed to load any FW image file
Jun 29 14:33:22 localhost kernel: ivtv: i2c attach [client=cx25840[50],ok]
Jun 29 14:33:22 localhost kernel: ivtv: i2c attach [client=wm8775[50],ok]
Jun 29 14:33:22 localhost kernel: ivtv: Encoder revision: 0x02040024
Jun 29 14:33:22 localhost kernel: ivtv: Encoder Firmware may be buggy,
use version 0x02040011
Jun 29 14:33:22 localhost kernel: ivtv: Configuring WinTV PVR 150 card
with 5 streams
Jun 29 14:33:22 localhost kernel: ivtv: Registered v4l2 device,
streamtype 0 minor 0
Jun 29 14:33:22 localhost kernel: ivtv: Create DMA stream 0 using 128
16384 byte buffers  0 kbytes total
Jun 29 14:33:22 localhost kernel: ivtv: Registered v4l2 device,
streamtype 1 minor 32
Jun 29 14:33:22 localhost kernel: ivtv: Create DMA stream 1 using 97
21600 byte buffers  0 kbytes total
Jun 29 14:33:22 localhost kernel: ivtv: Registered v4l2 device,
streamtype 2 minor 224
Jun 29 14:33:22 localhost kernel: ivtv: Create DMA stream 2 using 60
34656 byte buffers  0 kbytes total
Jun 29 14:33:22 localhost kernel: ivtv: Registered v4l2 device,
streamtype 3 minor 24
Jun 29 14:33:22 localhost kernel: ivtv: Create DMA stream 3 using 455
4608 byte buffers  0 kbytes total
Jun 29 14:33:22 localhost kernel: ivtv: Registered v4l2 device,
streamtype 4 minor 64
Jun 29 14:33:22 localhost kernel: ivtv: Create stream 4 
Jun 29 14:33:22 localhost kernel: ivtv: Setting Tuner 47
Jun 29 14:33:22 localhost kernel: tuner: type set to 47 (LG NTSC (TAPE
series)) by ivtv i2c driver #0
Jun 29 14:33:22 localhost kernel: ivtv: Switching standard to NTSC.
Jun 29 14:33:22 localhost kernel: ivtv: Initialized WinTV PVR 150, card #0
Jun 29 14:33:22 localhost kernel: ivtv: ====================  END INIT
IVTV  ====================

Thanks for any help in advance,
Paul