[mythtv-users] can't select channel

[Aaron Stewart]

Check and make sure that tuner.o/tuner.ko (kernel 2.4 vs 2.6) is 
available.. ivtv doesn't require that you have an add below line in your 
modules.conf, since it will insmod tuner for you, but if it isn't there, 
it won't choke, and it won't tell you either (short of some rather 
cryptic and uninformative i2c errors).


Phill Edwards wrote:

> I had that too and it turned out that I didn't have the correct 
> channel number (for the frequency) against the offending channel in 
> the setup screens. Check that they are correct for every channel and 
> then try again.
>
> Regards,
> Phill
>
>> From: Daniel Polak <daniel at sys.nl>
>> Reply-To: Discussion about mythtv <mythtv-users at mythtv.org>
>> To: Discussion about mythtv <mythtv-users at mythtv.org>
>> Subject: [mythtv-users] can't select channel
>> Date: Mon, 01 Nov 2004 20:22:16 +0100
>>
>> For some reason I can't select one of my channels.
>> In the channel editor everything seems ok but when I choose the 
>> channel MythTV appears to switch but then remains on the original 
>> channel.
>> When moving from the previous channel to the channel that doesn't 
>> work I end up at my last channel.
>> Recording doesn't work either.
>> Any idea what is wrong here?
>>
>> Daniel
>>
>> _______________________________________________
>> mythtv-users mailing list
>> mythtv-users at mythtv.org
>> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
>
>
>------------------------------------------------------------------------
>
>_______________________________________________
>mythtv-users mailing list
>mythtv-users at mythtv.org
>http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>  
>