[mythtv-users] Upgrade to 0.15 from 0.14 - Can't change channel(but guide shows programs)

[Mike Jasper]

On 5/27/2004 10:30 PM, Darren Richards wrote:

>>>All you should have to do is run setup and go into
>>>the input connections
>>>section and re-do that part.
>>>
>>>Isaac
>>
>>Issac,
>>
>>It turns out that just changing the cable name on the
>>two tuner inputs on my PVR-250 cards wasn't enough.  I
>>had to actually delete all of the card configurations
>>and rebuild them (answer yes to both questions in
>>mythtvsetup, not just delete the channel
>>configurations).
>>
>>Seems to be working fine now though - thanks for the
>>quick response.
>>
>>-- Joe
> 
> 
> Joe,
> 
> Did you do anything else to get it to work?  I've  deleted all my
> configuratons (numerous times) and re-set everything up, but I'm still stuck
> with one channel.  All my guide information is there and the channels and
> capture card seem to be set up properly.  I'm stumped.


After setting up your video source under "Video source," you need to go 
into "Input connections" and assign your new video source to an input on 
each tuner card.  It's not enough to just set up the capture cards 
themselves.

In my case, I have my video source (analog cable) assigned to Tuner 0 on 
each of my PVR-250s (/dev/video0 and /dev/video1).