[mythtv-users] Frequency off on channel 5 and 6

[Mark Haislip]

Hello Isaac,

Tuesday, May 6, 2003, 8:35:03 PM, you wrote:

IR> On Tuesday 06 May 2003 07:45 pm, Mark Haislip wrote:
>> I am using the current "production" release 0.8. United
>> States in the Detroit area of Michigan. Cable connection. It's in
>> pre-production in the living room and I have one minor snag.
>> The frequency being off on just a couple
>> of channels?! For some reason channel 5 and 6 are are 35Mhz too
>> low(discovered with xawtv/right arrow). All other channels seem to
>> come in just fine. No matter what I put in the
>> settings.txt file(us-cable, etc.), nothing seems to help. Any
>> suggestions

IR> Well, settings.txt doesn't exist in 0.8 -- you should set that through the 
IR> setup program, in the General section..  But, have you tried us-cable-hrc?

IR> Isaac
IR> _______________________________________________
IR> mythtv-users mailing list
IR> mythtv-users at snowman.net
IR> http://lists.snowman.net/cgi-bin/mailman/listinfo/mythtv-users

couldn't find the settings in 'General'?? So I played a bit with
xawtv:

us-cable - works as described. good except channel 5 and 6
us-bcast - same as above.
us-cable-hrc - all channels now come in but out of tune.
All appear to be 20 or so Mhz too low and can be tuned using the right
and left arrows with xawtv.

I am sure that when I find the settings for myth, myth will behave in
the same way. Still not sure how I am going to fix this?!?!

Any suggestions?

-- 
Best regards,
 Mark                            mailto:mark at voxpopzine.com