[mythtv-users] IR Blaster with Spectrum STB

[mythtv]

On 5/6/20 12:57 PM, James B Huber wrote:
> On Wed, 2020-05-06 at 11:01 -0500, mythtv wrote:
>> On 5/6/20 8:27 AM, Greg wrote:
>>>
>>> On 5/5/20 5:45 PM, mythtv wrote:
>>>> Is any using an IR blaster with the following equipment? I just
>>>> got
>>>> Spectrum and cannot find a working solution to change channels.
>>>> I have 2 rs232 serial blasters that worked with uverse but for
>>>> some
>>>> reason are not working well so I'm thinking about building a
>>>> multi-blaster from a raspberry pi. I can get lirc working but
>>>> when I try
>>>> to record the codes from the remote, all I get is zeroes:
>>>>
>>>> _________________________________________
>> mythtv-users mailing list
>> mythtv-users at mythtv.org
>> http://lists.mythtv.org/mailman/listinfo/mythtv-users
>> http://wiki.mythtv.org/Mailing_List_etiquette
>> MythTV Forums: https://forum.mythtv.org
> 
> Not that this helpful for you, I have Spectrum (originally Brighthouse)
> and when the change occurred, they switched out all the set-top boxes,
> but NOT the remnotes....
> 
> My original LIRC config still works, with any of the bozes they have
> sent me.
> It's below:
> 
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://lists.mythtv.org/mailman/listinfo/mythtv-users
> http://wiki.mythtv.org/Mailing_List_etiquette
> MythTV Forums: https://forum.mythtv.org
> 
Well, I was hopeful, but I plugged these codes into lirc and they had no
effect. I appreciate you sending them though.