[mythtv-users] IR Blaster with Spectrum STB
mythtv
mythtv at mdabbs.org
Wed May 6 16:01:55 UTC 2020
On 5/6/20 8:27 AM, Greg wrote:
>
> On 5/5/20 5:45 PM, mythtv wrote:
>> Is any using an IR blaster with the following equipment? I just got
>> Spectrum and cannot find a working solution to change channels.
>> I have 2 rs232 serial blasters that worked with uverse but for some
>> reason are not working well so I'm thinking about building a
>> multi-blaster from a raspberry pi. I can get lirc working but when I try
>> to record the codes from the remote, all I get is zeroes:
>>
>> begin remote
>>
>> name s4
>> bits 0
>> flags CONST_LENGTH
>> eps 0
>> aeps 0
>>
>> one 0 0
>> zero 0 0
>> gap 50000
>> toggle_bit_mask 0x0
>> frequency 38000
>>
>> begin codes
>> BTN_1 0x0
>> BTN_2 0x0
>> end codes
>>
>> end remote
>>
>>
>>
>> The STBs are an Arris DCX3200 and DCX3220
>> The remotes are URC1160.
>>
>> Please help, my Myth system is completely broken right now.
>> _______________________________________________
>> mythtv-users mailing list
>> mythtv-users at mythtv.org
>> http://lists.mythtv.org/mailman/listinfo/mythtv-users
>> http://wiki.mythtv.org/Mailing_List_etiquette
>> MythTV Forums: https://forum.mythtv.org
>
> I use a pair of DCX3200's with Spectrum,but I use Fire wire on one and
> a rs232 changer called MyBlaster (no longer available) on the other..
> This setup works flawlessly,and it takes LIRC out of the picture.. What
> are your RS232 devices? When I first got mine more than 15 years ago, I
> had problems with permissions on the serial ports,so I would look there
> first... One other problem I encountered was I needed to add dialout to
> my groups..
>
> Greg
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://lists.mythtv.org/mailman/listinfo/mythtv-users
> http://wiki.mythtv.org/Mailing_List_etiquette
> MythTV Forums: https://forum.mythtv.org
My only problem is that I don't have the lircd.conf file with the actual
codes of the remote. When I use lirc/irrecord to create the conf file, I
end up with every button just having a zero code for it. So in the end,
no matter what button I push or send, it all appears to be the same
button. (See above with the 0x0). I just need a decent conf file that
has the correct codes for the box. My actual ir blaster hardware is fine.
More information about the mythtv-users
mailing list