[mythtv-users] 'Upcoming Recordings' screen: tuner identity
Mike Bibbings
mike.bibbings at gmail.com
Tue Nov 12 21:31:24 UTC 2019
On 12/11/2019 20:44, John Pilkington wrote:
> I put a comment about this in Ticket #13501, and was invited to ask on
> a mailing list. Here goes:
>
> I have 3 OTA multirec-capable hardware tuners on this box; sometimes
> (trees, rain, wind, or when making several simultaneous recordings)
> their outputs may get degraded, and I like to know and perhaps control
> which device will be used for a planned recording. The frontend
> 'Upcoming Recordings' screen shows this.
>
> But when the recordings are in progress, the number (and the colour)
> changes, showing a virtual tuner number instead. It used to be
> possible (though tedious) to have mythtv-setup create virtual tuner
> numbers in blocks, say 1-5, 6-10, 11-15 with a clear relationship to
> the hardware device, but I'm not sure if 'schedule as a group' will do
> that. I have the impression that the virtual tuner numbers will be
> assigned as the need arises, so that there will no longer be a fixed
> relationship.
>
> I know that highlighting in 'Watch Recordings' and hitting 'Info'
> twice will show the 'Recording Input', which does look to be firmly
> tied to the hardware. Would it be better to display that identifier,
> or the 'real' tuner number in 'Upcoming Recordings' ? Doing that would
> also make it obvious when multirec was happening.
>
> If it matters, I'm using Myth-Center-Wide with a few minor tweaks. I
> don't think they are affecting this.
>
> John P
>
I have a quad card DVB-T/T2 for UK Freeview setup where inputs 1-10 are
for tuner 1 named fv1, 11-20 for tuner 2, named fv2, 21-30, named fv3
for tuner 3 and 31-40, named fv4 for tuner 4
In Upcoming Recording sscreen it shows for Myth Center Wide 1.7 the
input number on the right hand side of the screen, in Steppes it shows
(fv<n>) on the left hand side of the screen).
I set it up as follows:
-Add first Capture Card
-Add Video Source, if required
-Input Connections give it a display name e.g. for tuner 1, I used fv1,
tuner 2, fv2 and so on, set Video Source etc.
and in Interactions between inputs set Max Recordings to what you
want, in your case 5 (never gets this high in reality), with Schedule as
Group unchecked.
-Then add second Capture Card, do the Input Connections stuff.
-Then add 3rd Capture Card, do the Input Connections stuff.
-Then 4th Capture Card, do the Input Connections stuff.
You can safely do a Delete All Capture cards (not Delete Capture Cards
on xxxx) and then add the Capture Cards back in one at a time, all
tuning data is held under the Video Source (so do not delete any Video
Source).
As usual, you might want to do a database backup before doing any of the
above, just in case.
Mike
More information about the mythtv-users
mailing list