[mythtv-users] mythtv-users Digest, Vol 183, Issue 3

[Jim Best]

    On 06/02/2018 09:01 AM, Jim Best wrote:
    > I am using same Inteset USB receiver (with inteset remote) that works just fine with on my other front ends that are on xenial based mythbuntu.  The remote 'works' on pi only in the sense that I can navigate menu items, but mappings like 'menu' or 'pause' fail.  It is not running through the TV.  On my other frontends I am using mythbuntu with .29 repositories and set up of lirc was a no brainer.  From what I read, MCE is supposed to be supported in kernel?
    >
    > I've also tried the GPIO connected ICSTATION IR transceiver, DMESG shows its connected on pin high 18, but I seem less successful than using USB method.
    Did you try using Setup -> Edit Keys on the frontend? Go to Global, 
    menu. Select to add a key and when it asks you to press the key, press 
    the appropriate remote button. If it sees the key press, you can assign 
    it and save and it should work. Repeat for any other keys on the remote 
    that do not work.

Thank you for the advice. This was quite helpful!

Regards,
Jim