[mythtv-users] HDHomerun Connect: "idle" tuner keep streaming
Mark Perkins
perkins1724 at hotmail.com
Sat Sep 23 10:33:34 UTC 2017
On 23 September 2017 6:03:58 pm "Janusz S. Bień" <jsbien at mimuw.edu.pl> wrote:
> On Sat, Sep 09 2017 at 7:10 CEST, jsbien at mimuw.edu.pl writes:
>> Hi!
>>
>> After the end of MythTV recording, when WebFrontend shows that none of
>> the encoders is recording, the tuner keep streaming to port 47224 of my
>> PC.
>>
>> When I try to stop this from the command line with
>>
>> hdhomerun_config <id> set /tuner0/channel none
>>
>> it stops (the LED goes off), but after some time it starts again streaming.
>>
>> hdhomerun_config <id> get /tuner0/status
>>
>> reports however tuning to a different channel.
>>
>> I will appreciate your comments and suggestions, as the situation is
>> rather annoying.
>
> I reported the problem on the SiliconDust forum
>
> https://forum.silicondust.com/forum/viewtopic.php?f=113&t=66337
>
> and got a suggestion that the culprit is the retrieval of EIT
> information by MythTV. This doesn't seem probable to me, but I would
> like to check it and possibly prove this is not the case. How to do it?
>
Try mythbackend -v eit --loglevel debug
>>
>>
>> P.S. Why 'ps x' doesn't show me the MythTV backend?
>
> Still curious.
>
> Best regards
>
> Janusz
>
You are running the command as the BE user? Works for me.
More information about the mythtv-users
mailing list