[mythtv-users] mythtv-setup issue: KWorld USB ATSC TV Stick UB435-Q V3

[Hika van den Hoven]

Hoi James,

Wednesday, March 25, 2015, 6:58:30 PM, you wrote:

> Here is some relevant dmesg output, by the way:

> [    4.779973] em28xx: New device  USB 2875 Device @ 480 Mbps (1b80:e34c, interface 0, class 0)
> [    4.779980] em28xx: DVB interface 0 found: bulk
> [    4.781045] em28xx: chip ID is em2874
> [    4.956943] em2874 #0: EEPROM ID = 26 00 01 00, EEPROM hash = 0x5d3e97ab
> [    4.956949] em2874 #0: EEPROM info:
> [    4.956953] em2874 #0:       microcode start address = 0x0004, boot configuration = 0x01
> [    4.979914] em2874 #0:       AC97 audio (5 sample rates)
> [    4.979920] em2874 #0:       500mA max power
> [    4.979925] em2874 #0:       Table at offset 0x24, strings=0x206a, 0x048a, 0x0000
> [    4.979995] em2874 #0: Identified as KWorld USB ATSC TV Stick UB435-Q V3 (card=93)
> [    4.980000] em2874 #0: dvb set to bulk mode.
> [    4.980093] usbcore: registered new interface driver em28xx
> [    4.983266] em2874 #0: Binding DVB extension
> [    4.993879] DVB: registering new adapter (em2874 #0)
> [    4.995395] em2874 #0: DVB extension successfully initialized
> [    4.995403] em28xx: Registered (Em28xx dvb Extension) extension
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://lists.mythtv.org/mailman/listinfo/mythtv-users
> http://wiki.mythtv.org/Mailing_List_etiquette
> MythTV Forums: https://forum.mythtv.org

If you don't see anything under /dev/v4l or /dev/dvb, then I would
just install the firmware I mentioned. It can't hurt. Also check
you're not using a usb3 port!

Tot mails,
  Hika                            mailto:hikavdh at gmail.com

"Zonder hoop kun je niet leven
Zonder leven is er geen hoop
Het eeuwige dilemma
Zeker als je hoop moet vernietigen om te kunnen overleven!"

De lerende Mens