[mythtv-users] Anyone Using LIRC on CentOS 6.6?

[Kirk Bocek]

On 6/3/2015 3:36 PM, Hika van den Hoven wrote:
> What is dmesg/your log saying about the initialization?
>
>

$modprobe -r mceusb
$modprobe -v mceusb
insmod 
/lib/modules/2.6.32-504.16.2.el6.x86_64/kernel/drivers/media/rc/mceusb.ko
$dmesg
usb 1-4: reset high speed USB device number 3 using ehci_hcd
usbcore: deregistering interface driver mceusb
Registered IR keymap rc-rc6-mce
input: Media Center Ed. eHome Infrared Remote Transceiver (0471:0815) as 
/devices/pci0000:00/0000:00:1d.3/usb5/5-1/5-1:1.0/rc/rc1/input15
rc1: Media Center Ed. eHome Infrared Remote Transceiver (0471:0815) as 
/devices/pci0000:00/0000:00:1d.3/usb5/5-1/5-1:1.0/rc/rc1
rc rc1: lirc_dev: driver ir-lirc-codec (mceusb) registered at minor = 0
mceusb 5-1:1.0: Registered Philips eHome Infrared Transceiver on usb5:2
usbcore: registered new interface driver mceusb

$service lirc restart
Stopping infrared remote control daemon (lircd):           [  OK  ]
Starting infrared remote control daemon (lircd):           [  OK  ]
$ir-keytable
Found /sys/class/rc/rc1/ (/dev/input/event14) with:
         Driver mceusb, table rc-rc6-mce
         Supported protocols: NEC RC-5 RC-6 JVC SONY LIRC
         Enabled protocols: LIRC
         Name: Media Center Ed. eHome Infrared
         bus: 3, vendor/product: 0471:0815, version: 0x0000
         Repeat delay = 500 ms, repeat period = 33 ms

$ls /dev/lirc* -la
crw-rw---- 1 root root 247, 0 Jun  3 16:29 /dev/lirc0

and in /var/log/messages:

Jun  3 16:29:29 marble lircd-0.9.0[1501]: error reading from /dev/lirc0 
(ret -1, expected 4)
Jun  3 16:29:29 marble lircd-0.9.0[1501]: No such device

So it is using /dev/lirc0. Should I force it to use /dev/input?