[mythtv-users] NVidia/overscan problem

Jay Ashworth jra at baylink.com
Mon Sep 23 19:13:19 UTC 2013


----- Original Message -----
> From: "Jerry" <mythtv at hambone.e4ward.com>

> Check out the second section on the wiki, entitled "With NVidia Cards
> and
> more recent nVidia drivers (greater than version 300)"
> http://www.mythtv.org/wiki/Overscan#Making_MythTV_fit_the_screen_on_a_TV

FWIW: I did find the overscan correction section of setup, and tried to 
run it, but I had two separate problems:

1) At first, I couldn't find the lower-right "arrow", because it was so far
off-screen that even the triangle wasn't visible.  and

2) When I did figure that out, and ran it up to where it belonged, Myth
violently overcorrected, leaving me a 20-30 px strip of desktop on bottom
and right.

Those might both be related to the scan conversion in the TV, but I'm not
betting on it.

And just to make this more complicated: when the TV is being fed the 
1080i from the GeForce... it's "Display" *says* it's 720p.  <sigh>

Cheers,
-- jra
-- 
Jay R. Ashworth                  Baylink                       jra at baylink.com
Designer                     The Things I Think                       RFC 2100
Ashworth & Associates     http://baylink.pitas.com         2000 Land Rover DII
St Petersburg FL USA               #natog                      +1 727 647 1274


More information about the mythtv-users mailing list