[mythtv-users] FW load problem after replacing Hauppauge cards
Jay Ashworth
jra at baylink.com
Tue Nov 26 18:15:31 UTC 2013
----- Original Message -----
> From: "Devin Heitmueller" <dheitmueller at kernellabs.com>
> It probably makes sense as a test to yank one of the cards out and
> reboot, so you can see which of the tuners failed to load firmware.
> This will also help ascertain if it's some sort of race condition
> related to the tuners being initialized in parallel.
Well, if either card is the only one, then all its relevant firmware
loads properly.
Yay.
I guess the next thing is to swap slots. I only have 2 -- getting a
motherboard over the counter with more than 2 PCI slots is effectively
impossible these days.
Cheers,
-- jra
--
Make Election Day a federal holiday: http://wh.gov/lBm94 100k sigs by 12/14
Jay R. Ashworth Baylink jra at baylink.com
Designer The Things I Think RFC 2100
Ashworth & Associates http://baylink.pitas.com 2000 Land Rover DII
St Petersburg FL USA #natog +1 727 647 1274
More information about the mythtv-users
mailing list