[mythtv-users] No longer tuning channels with Ceton card

[Michael A Weber]

On Apr 30, 2013, at 10:28 PM, Michael T. Dean wrote:

> On 04/30/2013 10:22 PM, Michael A Weber wrote:
>> All--
>> 
>> i recently re-installed my FusionHDTV card in the attempt to eventually cut the cable and go only over-the-air, and since that time I have had nothing but failed recordings via my Ceton card.  However, LiveTV via my Ceton card still worked.
>> 
>> So today, I figured I needed to delete the capture cards and input connections and start over.  So, I deleted all capture cards, deleted all input connections, re-configured the capture cards, and re-configured only the RCN-Digital lineup for the Ceton… then setup the connections to the four tuners on the Ceton card.  Then I ran mythfilldatabase --dd-grab-all.  After this point, I now can watch or record nothing.
>> 
>> I keep getting errors in LiveTV about a partial lock, and in the log I'm getting an error about Program #0 not found in PAT, which is what I was getting with recordings when I could previously watch LiveTV but record nothing:
>> 
>> CetonSH(192.168.75.22-0.0): TuneProgram(0) - Requested program not in the program list
>> Desired program #0 not found in PAT.
>> 			Cannot create single program PAT.
>> ProcessPAT: Program not found in PAT. Rescan your transports.
>> DTVSM(192.168.75.22-0.0): Program #0 not found in PAT!
>> Program Association Section
>>  PSIP tableID(0x0) length(17) extension(0x0)
>>       version(15) current(1) section(0) last_section(0)
>>       tsid(0) programCount(2)
>>   program number    10 has PID 0x0032
>>   program number    11 has PID 0x0033
>> 
>> I also tried clearing the Channel Map and re-downloading in my Ceton card, but that didn't help either.
>> 
>> I tried to look through some code for how the Ceton card grabs its information, but I couldn't find all the included classes.
>> 
>> Any ideas what is going wrong?
> 
> Sounds like it's your Video Sources that are messed up.  Make sure you have one for the Ceton and one for the OTA.  Clear out what you have, now, with "Delete all video sources" (not "Delete all video sources on <hostname>").
> 
> Mike
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://www.mythtv.org/mailman/listinfo/mythtv-users

Mike--

Sorry, that is something else I also did.  I did delete all video sources and even went into my SchedulesDirect account and deleted the OTA lineup so all that was returned for lineups when I created a new Video Source was my RCN Digital, which is my one-and-only Schedules Direct lineup and my one-and-only newly-created video source that I mapped to the Input Connections for the Ceton channels on the card.  My bad for not being more specific.

So, any other ideas?  I'm at a complete blank as this has never happened to me in all the years, even when I previously changed cards, changed cable providers, etc.

Mike