[mythtv-users] HVR-2250 - tuner unavailable

[Dan Littlejohn]

On Wed, Apr 11, 2012 at 10:40 PM, jacek burghardt <jaceksburghardt at gmail.com
> wrote:

>  You need to setup it as dvb. Can you post output of  "ls /dev/dvb/*" Did
> you setup source ?
>
> On Wed, Apr 11, 2012 at 9:02 PM, Dan Littlejohn <dan.littlejohn at gmail.com>wrote:
>
>> Having trouble with the analog part of a new HVR-2250 card.  Using Gentoo
>> and kernel 3.2.1 and it looks like the card is loading ok (below).  I
>> downloaded the firmware and put it in /lib/firmware, not sure if that is
>> still needed.  There are /dev/video0 and /dev/video1 entries and I added it
>> using the MPEG-2 in mythtv-setup, but the card shows up on myth as
>> "unavailable"  Not sure what I need to look for at this point.  I have read
>> what I can find, does anyone have any tips on getting this to work?
>>
>> Dan
>>
>> saa7164 driver loaded
>> saa7164 0000:02:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
>> CORE saa7164[0]: subsystem: 0070:8851, board: Hauppauge WinTV-HVR2250
>> [card=7,autodetected]
>> saa7164[0]/0: found at 0000:02:00.0, rev: 129, irq: 16, latency: 0, mmio:
>> 0xfb800000
>> saa7164 0000:02:00.0: setting latency timer to 64
>> saa7164_downloadfirmware() no first image
>> saa7164_downloadfirmware() Waiting for firmware upload
>> (NXP7164-2010-03-10.1.fw)
>> saa7164_downloadfirmware() firmware read 4019072 bytes.
>> saa7164_downloadfirmware() firmware loaded.
>> saa7164_downloadfirmware() SecBootLoader.FileSize = 4019072
>> saa7164_downloadfirmware() FirmwareSize = 0x1fd6
>> saa7164_downloadfirmware() BSLSize = 0x0
>> saa7164_downloadfirmware() Reserved = 0x0
>> saa7164_downloadfirmware() Version = 0x1661c00
>> saa7164_downloadimage() Image downloaded, booting...
>> saa7164_downloadimage() Image booted successfully.
>> saa7164_downloadimage() Image downloaded, booting...
>> saa7164_downloadimage() Image booted successfully.
>> saa7164[0]: Hauppauge eeprom: model=88061
>> DVB: registering new adapter (saa7164)
>> DVB: registering new adapter (saa7164)
>> saa7164[0]: registered device video0 [mpeg]
>> saa7164[0]: registered device video1 [mpeg]
>> saa7164[0]: registered device vbi0 [vbi]
>> saa7164[0]: registered device vbi1 [vbi]
>>
>> _______________________________________________
>>
>
>
Guess I should have specified that I am trying to get the analog section of
the card to work, trying to use the s-video input.  I have setup a source
in mythtv-setup.

Dan.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.mythtv.org/pipermail/mythtv-users/attachments/20120411/a47900b5/attachment-0001.html>