[mythtv-users] Using devinput but devinput lircd.conf file does not contain all my remote buttons on Harmony One

[Gabe Rubin]

On Sun, Jun 5, 2011 at 7:09 AM, Jarod Wilson <jarod at wilsonet.com> wrote:
> On Jun 4, 2011, at 6:34 PM, Gabe Rubin wrote:
>
>> Hi list,
>>
>> I have figured out how to transition from lirc_i2c to ir-kbd-i2c using
>> Fedora 14.  However, the /usr/share/lirc-remotes/devinput/lircd.conf
>> file does not contain codes for every button on my Harmony One (set up
>> as a MythTVKnoppMyth from the Harmony database).  How do I figure out
>> what the codes for these buttons are so I can modify the lircd.conf
>> file.  Or is there another remote I should set my Harmony up as?  I am
>> using the IR receiver from my PVR-350 card.
>
> modprobe ir-kbd-i2c debug=1
>
> Then look in dmesg for stuff along the lines of "ir hauppauge (rc5): ..."
> which should contain the raw signal data. Assuming that remote profile
> has more in it than just the Hauppauge remote's keys, the keytable for
> the driver needs to be extended. Verify you're getting stuff in dmesg for
> those additional keys, and I can try to walk you through extending the
> keytable as needed.
>

Thanks for the help.  There are 11 keys on my remote that are not
mapped in the lircd.conf file and I get no output for when using irw.

When I press them, I do get something in my dmesg.  Here is the dmesg
output for the keys that get no response in irw:


[936266.419959] ir-kbd-i2c: ir hauppauge (rc5): s1 r1 t0 dev=30 code=10
[936267.619954] ir-kbd-i2c: ir hauppauge (rc5): s1 r1 t1 dev=30 code=27
[936268.621952] ir-kbd-i2c: ir hauppauge (rc5): s1 r1 t0 dev=30 code=31
[936270.022946] ir-kbd-i2c: ir hauppauge (rc5): s1 r1 t1 dev=30 code=20
[936270.923949] ir-kbd-i2c: ir hauppauge (rc5): s1 r1 t0 dev=30 code=37
[936271.323946] ir-kbd-i2c: ir hauppauge (rc5): s1 r1 t1 dev=30 code=21
[936272.124948] ir-kbd-i2c: ir hauppauge (rc5): s1 r1 t0 dev=30 code=22
[936272.524945] ir-kbd-i2c: ir hauppauge (rc5): s1 r1 t1 dev=30 code=23
[936275.827947] ir-kbd-i2c: ir hauppauge (rc5): s1 r1 t0 dev=30 code=52
[936276.127948] ir-kbd-i2c: ir hauppauge (rc5): s1 r1 t1 dev=30 code=41
[936453.703960] ir-kbd-i2c: ir hauppauge (rc5): s1 r1 t1 dev=30 code=56

Not sure how to translate this information into syntax for my
lircd.conf file (or if I need to do something else).

Again, thanks for the help.