[mythtv-users] Masterbackend to shutdown slave

Viktor Wadskog wadskog at gmail.com
Thu Jan 6 22:47:05 UTC 2011


Hi!
I don't think there is an IP problem.
When I have both backends running the master tells the slave to record
shows without problem.

OK, but why must I configure commands on the slave, isn't it the
master who both wakes and shuts down ?

Shall I have the same command line on both master and slave ?

2011/1/6 Michael T. Dean <mtdean at thirdcontact.com>:
>  On 01/06/2011 10:29 AM, Viktor Wadskog wrote:
>>
>> Hi!
>> I have 2 mythbackends, one 24/7 on master with a dummy capture card and
>> then the slave, hosting 2 capture cards.
>>
>> So when not in use, I want my master to shutdown the slave and then wake
>> it when there is an upcoming recording.
>>
>> So on page 6 in mythtv-setups General section in the "slaveservers" box,
>> my master is set like this:
>>
>> Sleep command: "path to script that shutsdowns my slave"
>> Wake command: "MAC-adress to slave"
>>
>> Is that the right way to set it up ?
>>
>> The master never seems to shutdown the slave.
>> I have no upcoming recordings, I'm not connected with a frontend and there
>> are no jobs pending.
>>
>> What might be wrong ?
>
> Did you run mythtv-setup on every single slave backend and set Sleep
> command/Wake command for each?
>
> Also, sounds like the slave backend isn't properly connecting to the master
> backend--likely a problem with the IP address settings on the slave backend
> or something.
>
> Mike
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>


More information about the mythtv-users mailing list