[mythtv-users] How to limit 2xDVB-S (+DiSEqC) to 1 LNB at a time?
Simon Hobson
linux at thehobsons.co.uk
Sun Apr 26 16:04:55 UTC 2009
David Lister wrote:
> > Not that I have a lot of experience with DVB-S setups and DiSEq, but it
>> seems to me that on the adapter (or settopbox) "side" of the switch can
>> only be a single tuner. It seems to me there are only two solutions:
>>
>> 1) Remove the switch and run two coax cables from each tuner to each LNB
>> (1 to 1 connections)
>> 2) Make the LNBs twin LNBs, add a second switch and have both tuners
>> connect through a switch to these twin LNBs
>>
>> The first one would be the least expensive, but the second gives more
>> flexibility in recordings. Your current setup can maybe be used if you
>> use inputgroups:
>>
>> http://www.mythtv.org/docs/mythtv-HOWTO-12.html#ss12.6
>>
>
>I thought as much. Actually, I have quattro LNB's and I feed the
>whole house via the multiswitch. Quattros with their fixed outputs
>served by the switch alone was the most scalable solution I could
>find.
Yes, it is the most scalable - it's what large installations (like
blocks of flats/apartments) use to allow many users access to one
dish. I intend going that route when I get around to putting up a
dish for freesat. But ...
>Unfortunately, each room is provided with just one cable.
... it falls down if you run less cables than you need from the switch.
--
Simon Hobson
Visit http://www.magpiesnestpublishing.co.uk/ for books by acclaimed
author Gladys Hobson. Novels - poetry - short stories - ideal as
Christmas stocking fillers. Some available as e-books.
More information about the mythtv-users
mailing list