[mythtv-users] Compro VideoMate T-750
Rod
Rod at Rods.id.au
Sun Feb 10 08:34:35 UTC 2008
Hi, has anyone had any experiance with the above Video card?
Here is what I have found on this little card....
The RTC on the card, being a known chip, also linked into the
"Power-SW" wiring from the front panel simplifies the "power saving
feature, also the complexity across differing mobo's and their BIOS
timing circuits
Onboard, it has the following devices.
DVB-in -> QT1010 -> CE6353 -> SAA7135
Analog-in -> XC2028 -> SAA7135
Composite-in -> SAA7135
Radio-in -> SAA7135
RTC (DS1337)-> SAA7135 (I2C)
EEPROM -> SAA7135 (I2C)
I have QT1010, SAA7133/5, XC2028, DS1337 loaded as a modules
The RTC is connected to the I2C buss from the SAA7135, the INT
output is connected thru a custom driver chip (seems like just a custom
driver similar to a ULN2004 driver chip, I doubt its I2C, it wouldn't
buzz out to that chip
I2C addresses
QT1010 = 0xA0 DVB Front End
DS1337 = 0xD0 RTC, the Alarm out restarts the computer (I
think)
XC2028 = 0x Analog/Radio front End (Difficult to get
address info)
CE6353 = 0x1E Nordig Unified DVB-T CDFDM Terrestrial
Demodulator
QT1010 (module)
DS1337 (module)
XC2028 (CX8800 = module) or CX88... series modules
CE6353 not sure of the module for this yet... not sure how
programmable it is
Have a PDF of the QT1010, cannot find the linky again
DS1337 http://datasheets.maxim-ic.com/en/ds/DS1337-DS1337C.pdf
CE6353 http://download.intel.com/design/celect/datashts/D55752.pdf
CE6353 looks pin-for-pin compatable for the following (Zarlink Devices)
http://www.pctuner.ru/files/pdf/zarlink_mt352.pdf
http://www.pctuner.ru/files/pdf/zarlink_zl10353.pdf
Also the I2C address on the chip Doc refers to SADD0:4, in the doc,
it said that "In the current TNIM evaluation application, the 2-wire bus
address is 0001 111 R/ W with the pins connected as
follows:"
For the T-750 the configuration is 0001 111r/w Strange how they
didn't change it, but thats what happens when you follow App notes,...
So, I hope this helps someone getting these little beasties going, I
would love to utilise them ;o)
More information about the mythtv-users
mailing list