[mythtv-users] nuvexport is not honoring my cutlist --help

[Mike LaPlante]

Steve Peters - Priority Electronics wrote:
> -----Original Message-----
> From: mythtv-users-bounces at mythtv.org
> [mailto:mythtv-users-bounces at mythtv.org] On Behalf Of Mike LaPlante
> Sent: Monday, September 24, 2007 2:06 PM
> To: Discussion about mythtv
> Subject: Re: [mythtv-users] nuvexport is not honoring my cutlist --help
>
>
> Steve Peters - Priority Electronics wrote:
>   
>> Hello, I'm using nuvexport to export my recordings.
>> For some shows the commercial flagger doesn't do a good job, so i
>> manually go in and fix it. I know the changes i make are saved (cause 
>> life is good after i fix the commercial breaks). So this weekend i 
>> decided to export to xvid a few of the recordings, only to find out 
>> that not only did nuvexport ignore my cutlist and use the original 
>> commercial cutlist, but when i go back and play the original 
>> recordings, my cutlist work is gone, so i have to redo it.
>>
>> What is going on here? How do i fix it? The nuvexport page in the myth
>> wiki strongly suggests to create a cutlist..and that's exactly what 
>> i'm doing.
>>  
>> -Thanks
>> -Steve
>>   
>>     
> When I run nuvexport it asks me if I would like to honor the cutlist and 
> I answer 'yes'. If you're not running through the step by step wizard 
> then edit the /etc/nuvexportrc or ~/.nuvexportrc and set the 
> honor_cutlist option.
>
> Mike
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
>
>
> OK, in my nuvexportrc file, there is "use_cutlist = yes" and "gencutlist =
> yes" as well as "mythtranscode_cutlist = yes"
>
> When I run nuvexport there is an "enable myth cutlist" option, and by
> default it says yes. 
>
> Just to make sure we're on the same line here, I never have a problem
> getting rid of the commercials when the comm flagger runs on a recording,
> it's just when I create the cutlist manually. Problem is that the comm
> flagger isn't perfect. I've exported hundreds of recordings without a
> problem, only lately have I begun exporting Seinfeld recordings where I have
> to fix the comm flagging mistakes.
>
> I don't see where there is an honorcutlist option. Please advise
>
> -Thanks
> -Steve
>
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>   
Hmm, well I'm not an expert here. Maybe you don't need the gencutlist if 
you are manually doing it with Edit while watching the show. Perhaps 
with that option enabled it is overwriting your manual efforts.

I usually manually fix up an episode then just run through wizard via 
CLI and hit enter when it ask "enable myth cutlist". And it works.

My nuvexportrc (which I've never edited from the default) has 
gencutlist=no, but its commented out, and use_cutlist=yes and 
uncommented same goes for mythtranscode_cutlist=yes.

Hope that helps.

Mike