[mythtv-users] IR failed
Anil Gupte
anil-list at icinema.com
Wed Oct 31 10:18:24 UTC 2007
I have tried that, but I cannot get that card to go into the slot unless I cut
pieces off the case. I am probably going to remove the otherboard from the
case, but I need a few ours free to do that, and I have just been putting it
off. I'll get back to you when I can. Meanwhile, is there any way to debug the
loading of these programs? i.e. /usr/local/sbin/lircd and
/usr/local/bin/lirexec -d /home/mythtv/.mythtv/lircrc
Thanx,
Anil Gupte
www.keeninc.net
www.icinema.com
----- Original Message -----
From: "Nick Morrott" <knowledgejunkie at gmail.com>
To: "Discussion about mythtv" <mythtv-users at mythtv.org>
Sent: Thursday, October 25, 2007 8:16 PM
Subject: Re: [mythtv-users] IR failed
On 25/10/2007, Anil Gupte <anil-list at icinema.com> wrote:
> Now, the only ting I can think of and this is way, way out there, but really
> it
> is the only thing, is this....
>
> The Silverstone has a riser card because the card des not fit vertically - in
> fact this is the only way to get an card into that system. I am thinking that
> riser card is eating some voltage. Since the PVR-350 is working fine
> otherwise,
> it must be that increased impedance on the riser card is killing the
> relatively
> low voltage output of the PVR-350's IR input. However, it was working before
> so
> the theory has some failings, but I can't think of anything else.
Anil,
If you are sure it is not a LIRC config issue, can you test the card
in the PCI slot directly with the case open, instead of using the
riser?
--
Nick Morrott
MythTV Official wiki:
http://mythtv.org/wiki/
MythTV users list archive:
http://www.gossamer-threads.com/lists/mythtv/users
"An investment in knowledge always pays the best interest." - Benjamin Franklin
_______________________________________________
mythtv-users mailing list
mythtv-users at mythtv.org
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
More information about the mythtv-users
mailing list