[mythtv-users] lirc mceusb2 with ir blaster
Bob
mythtv at cox.net
Sat Oct 13 00:06:22 UTC 2007
Keith Lawson wrote:
> On Sun, Oct 07, 2007 at 03:37:00PM -0700, Bob wrote:
>
>> Any one have any luck with the irblaster that comes with the mceusb2 IR
>> receiver? I can't get mine to work and I have verified that it is
>> sending some type of output (using my camcorder to watch for IR pulses).
>>
>> I am currently using an IR blaster on my serial port, but I would like
>> to transition to this USB device. I feel confident my lirc
>> configuration is correct because everything work fine with the serial port.
>>
>> I have heard the LED that comes with the mceusb2 is very weak so I
>> constructed a new one using the same high-powered LED that I have on my
>> serial port. Still no luck.
>>
>> lsusb: Bus 001 Device 002: ID 1784:0001
>>
>> lircd --version: lircd 0.8.2-CVS-pvr150
>>
>> _______________________________________________
>> mythtv-users mailing list
>> mythtv-users at mythtv.org
>> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>>
>
> I'm using that setup with a Rogers cable (Canada) set top box (STB) and it works fine.
>
> Did you define your STB in lircd.conf and test with irsend?
>
> Keith.
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
>
Yes, everything is defined correctly because I am using the same
lircd.conf that I was using with my serial IR blaster.
I used the xmode2 program to compare IR signals from the actual remote
with the signal from the blaster and they are a little bit different.
I am going to try to change my lircd.conf a bit more in hopes I can get
it to work.
Bob
More information about the mythtv-users
mailing list