[mythtv-users] mythfrontend channel changing

[Peter Rozental]

No, I do not have any other wireless devices. Another person suggested to
use a different channel changing script, which I did. That did not fix it
either. When I run the script it always works fine, no extra signals. When I
run the remote through myth I still get extra keys. 

103 becomes 103 1 
53 becoes 53 3

I increased my repeat to 10 and still no luck.

-----Original Message-----
From: mythtv-users-bounces at mythtv.org
[mailto:mythtv-users-bounces at mythtv.org] On Behalf Of Brian Walter
Sent: Wednesday, June 06, 2007 6:26 AM
To: Discussion about mythtv
Subject: Re: [mythtv-users] mythfrontend channel changing

Brad DerManouelian wrote:
> On Jun 5, 2007, at 4:08 PM, Peter Rozental wrote:
>
>   
>> Ok,
>>
>> I have finally successfully compiled a lircd.conf file that from the
>> terminal works great. I can change channels consistently without  
>> issue.
>> The problem that I now have is when I fire up mythfrontend I get  
>> duplicate
>> channel change sends. Meaning that if I press 120 on the remote I  
>> get 120
>> 0, so the channel goes to 0. Or if I send 45 it will send 45 5.  
>> There is
>> about a 1-1.5 second delay between the 45 and 5. This does not  
>> happen when
>> I run my channel change script from the terminal. Any Ideas?
>>     
>
> Are you sure you don't have 2 instances running?
>
>   
One thing I've run into - do you have an IR wireless keyboard?  The ir 
receiver for the keyboard will also capture my remote's signals - and if 
I have keyboard commands in the remote, I get a 'double' entry.

Brian
_______________________________________________
mythtv-users mailing list
mythtv-users at mythtv.org
http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users